Glass mold preheat station

Tue, 30 Jun 2026 02:30:09 +0800

Out on the line, the mold has to get to setpoint fast—and hold there, rock steady. If the thermal field starts to drift, you’ll see uneven sag, edge waves, and tempering stress that shows up as optical distortion. We built the glass mold preheat station to take that guesswork out of the first minute of the cycle. What matters under the hood We run quartz short-wave infrared emitters in a compact footprint, sized to match press and bending mold layouts. These heaters snap to temperature fast, then hold steady. Control is done off thermocouple feedback on the mold itself, not on the heater body, so the setpoint tracks what the glass actually sees. Power and voltage are matched to your plant distribution, and the terminal layout follows the same wiring practice you already use on OEM modules. The payoff is repeatable soak temperature with tight band control—so the first sheet and the thousandth start from the same place. Why this matters on a tempering and bending line In tempering and bending, the preheat step sets the whole thermal story. A stable mold temperature cuts thermal shock at initial contact, reduces edge stress, and lowers breakage when you hit the bend. Faster warm-up means shorter changeovers, so you can run more styles per shift without burning minutes waiting on heat. Energy use drops because the quartz emitters heat the mold directly, with less wasted convection into the air around the machine. In practice, that means fewer scrap sheets, fewer operator tweaks, and optical quality that holds across the run. What you need to plan for This station drops into a lot of press and bending lines, but you do need to pay attention to mounting geometry and clearances. Make sure your power is clean, and verify that mold emissivity and contact points are consistent—reflective surfaces and sloppy contact can create local hot spots. Expect shorter warm-up times, but also budget a week up front to tune the PID and map temperature across the mold face. Once it’s set, the station runs with minimal maintenance, and emitter life keeps you through long campaigns without constant changeouts.

Station on Warm IR Heater Online Mall

Glass mold preheat station