Glass bending furnace temperature

Wed, 29 Jul 2026 06:05:24 +0800

The Struggle with Long Glass Bending Kilns (and How to Fix It)

Most infrared lamps stop at about a meter. That’s fine for small jobs, but when you’re running a massive tunnel kiln, those gaps between the lamps become a real headache. You get these cold spots. And cold spots mean trouble. Your glass bends unevenly, you get internal stress, and suddenly you’re looking at a piece of scrap. To stop that from happening, we build custom heating units that push past the 2-meter mark. No gaps. No cold spots. Just steady heat. The trick to long-form tubes You can’t just stretch a piece of quartz and call it a day. If you do, you’ll end up with hotspots that can ruin a sheet of glass in seconds. We spend a lot of time tweaking the voltage and wattage distribution. The goal is simple: the heat needs to feel the same at the beginning of the tube as it does at the end. One thing to watch out for? Your power supply. These long, high-wattage tubes pull a lot of juice. If your wiring or breakers aren’t up to the task, you’re going to trip the whole system the moment you start ramping up the heat. It’s a frustrating way to start a shift. Built to last (and stay straight) When a tube gets that long and hot, it wants to sag. To fight that, we use heavy-wall quartz. It keeps the tubes rigid so they don’t bow under their own weight. We also pack them in a continuous layout. We keep the spacing tight so you don’t get that annoying “zebra striping” on your glass. Plus, we use industrial connectors that can handle the constant expanding and contracting. They take a beating, but they hold up. A few things to keep in mind These arrays are great for those huge architectural pieces, but there’s a catch: they’re fragile. A 2-meter quartz tube is a lot easier to snap than a short one. Your team has to be careful during installation. And please, don’t tighten the mounting brackets too much. The glass needs room to breathe and expand linearly. If it’s clamped too tight, the tube will bow, hit a stress point, and eventually just burn out. Give it some room, and it’ll treat you right.

Bending on Warm IR Heater Online Mall

Glass bending furnace temperature

The Struggle with Long Glass Bending Kilns (and How to Fix It)